|Size (L x W x H)||560 mm x 143 mm x 56 mm|
- Tt LCS Certified
- Contains: V-Tubler PETG Tube 12mm OD 500mm (4 Pack)
- Contains: Pacific G1/4 PETG Tube 12mm OD Compression Fittings – Black
- Contains: Pacific G1/4 PETG Tube 90-Degree Compression 12mm OD – Black
Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks
- To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
- Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
- Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop setup
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
- Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
- DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
- Fill the reservoir to the top as it will prevent air from going into the pump
- If necessary tilt the system slightly from side to side to bleed the air out of the loop.
- Place some paper towels under fittings and joining points to test for leaks.
- Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop
- Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
- Coolant might fade over time.
|Dimension||560(L) x 143 (W) x 56 (H)|
OD : 12mm , ID : 10mm , L : 500mm
- Pacific G1/4 PETG Tube 12mm OD Compression – Black x6
- Pacific G1/4 PETG Tube 90-Degree compression 12mm OD – Black x2
- V-Tubler PETG Tube 12mm OD 10mm ID 500mm 4Pack x1
- Silicone cord x 1
- Thermaltake Pacific Fitting Starter Kit